by Jim Jackson | Jun 29, 2021 | Gen 1.3 - Troubleshooting
Symptoms: Visible Leak Portion(s) of nozzle circuit not misting adequately Drum’s actual fluid level runs empty before the controller’s volume gauge Troubleshooting Tests: 1. Visually Inspect Nozzle Circuit To Find Leak Run an inspection mist cycle by...
by Jim Jackson | Jun 29, 2021 | Gen 1.3 - Troubleshooting
This can be the root cause of an error 3 if the nozzle circuit is installed at a higher than normal (12 feet or above) height above the misting unit. An excess amount of fluid from the nozzle circuit lines can drain back into the misting unit during the post-mist hold...
by Jim Jackson | May 18, 2021 | Gen 1.3 - Troubleshooting, Gen 3 - Troubleshooting, Nozzle Circuit
Symptoms: Error 3 on controller/High AFR in Data menu Visible Leak Portion(s) of nozzle circuit not misting adequately Insecticide’s fluid level runs empty faster than expected Record Info and Run Troubleshooting Tests: 1. Before running ANY mist cycle, record...
by Jim Jackson | May 20, 2020 | Gen 1.3 - Troubleshooting, Gen 3 - Troubleshooting
Common Root Causes: Unit does not recognize remote transmitter. See Controller: “Learning” the iMist2-ready Handheld Remote Transmitter System Mode is set to OFF. Reset System mode to AUTO mode or REM (or...
by Jim Jackson | May 20, 2020 | Gen 1.3 - Troubleshooting, Gen 3 - Troubleshooting
Potential Root Causes: Unit does not recognize remote transmitter. See Controller: LRNing the Remote Transmitter System Mode is set to OFF. Reset System mode to AUTO mode or REM (or ON). See Controller: Setting...
